Ridge and furrow aligned north to south.

Ridge and furrow.

Ridge and furrow to the north of the farm, aligned north to south.

Evaluation trenching on the site of South West Farm (by Archaeological Services Durham University) in 2006 recorded a manmade ditch, huge in proportions, some 2m wide. Broken quernstones of late Iron Age/Romano-British date had been deposited in the terminus of the ditch. There were two fragments of disk querns (one 40cm in diameter, 11cm thick at eye, hourglass shaped, eye 4cm wide at ends and 3cm wide at centre; the other was approx 51 cm, flat top and bottom, curved outer wall, 10.5cm thick at rim/eye, 9.5cm just outside rim, 7cm at start of curve of outer wall, eye diameter 10cm). The third fragment was of a beehive quern upper stone. Part of hopper, lip and outer wall extant, no part of feed-pipe. Groove, 35mm extant, 5mm wide and 3mm deep on part of outer wall. Evidence of secondary use for unknown purpose. The ditch probably forms part of an enclosure. Evaluation report forthcoming. Need C14 date from ditch fill.

According to Bateman, prehistoric burials were found in hills to the west of Ryhope, where Ryhope Colliery was located.

Ryhope Mill is shown on An Eye Plan of the township of Ryhope 1869. A wind mill is also depicted on a plan of farms in Ryhope, 1796-1804. The mill is not shown on a plan of 1831, when the land belonged to Miss Scurfield's representatives and William Mornman. Geophysical survey in 2014 identified a rectilinear anomaly c.40m x 40m enclosing the probable mill structure. Evaluation trenching over this anomaly in 2014 recorded two stone walls. The first ran east-west and was 0.95m wide and survived to one course high. It was constructed of large sandstone blocks bonded with lime mortar. The second wall ran north-south, was 0.8m wide and survived to two courses high. It was built of smaller sandstone blocks. The walls may relate to the mill. A large pit had been excavated around the walls, cut into the natural subsoil. It was 8.5m in diameter and 2m deep. The pit was filled with sandstone rubble within grey-brown clay-silt. Significant quantities of animal bone, post-medieval pottery, iron nails, glass fragments, clay tobacco pipe and broken bricks were also found amongst the rubble. Overlying the rubble deposit and abutting both walls was a layer of orange-brown sandy clay. To the south of the pit and walls was a linear gully 0.9m wide and 0.25m deep. It was aligned east-west and was filled with a red-brown sandy clay containing post-medieval pottery, clay tobacco pipe, animal bone, glass and iron. To the west of the mill was another shallow gully, 0.8m wide and 0.15m deep, running north-west to south-east. It was filled with grey-brown sandy clay from which one fragment of post-medieval pottery was recovered. Finds included 178 pottery sherds. These included two small medieval sherds, a few sherds of tin glazed earthenware and slipware of possible 17th or 18th century date and the rest was mainly brown glazed coarse and fine wares and late blackware of 18th or 19th century date. The most interesting artefacts were the animal bones. The artefacts were mainly made from horse bones They have a square hole in the proximal and distal shaft and one or two smooth scoops cut on the anterior medial and/or lateral shaft. Only one of the objects was made from a cattle bone, from a large improved type of cattle bred from the later 18th century. Similar bone artefacts made from horse metapodials were found during excavations of a possible medieval postmill at Hartlepool. This suggests that the artefacts formed an integral part of the working mechanisms of the mill, part of the gearing and bearing mechanisms. The square hole was where they were inserted onto square iron shafts. The smooth scoops were bearing surfaces for round turning beams. Tallow would have been used for lubrication. Bone was a cheaper raw material than metal (brass, bronze and gun metal bearings were used at a post-medieval windmill on Wimbledon Common). Other animal bone recovered from the Ryhope Mill (cattle, horse, sheep or goat and pig) displayed butchery chop marks and dog gnawing marks. This may indicate human consumption of shin beef and offcuts for dog food. The association of a large guard dog with the mill goes back to the medieval period (Backhouse, 2000, p 28). One possible dog fibula was recovered. Four pieces of copper alloy were found. One piece has possible punched decoration. A copper alloy pin 24mm long and 1mm wide and a bent strip of copper allo sheet 69mm long, 913mm wide and 1mm thick was recovered. Further archaeological excavation is required.

Mill House is shown on Robson's Plan of Bishopwearmouth, 1831 (possibly lavelled Hill House), Bell's Plan of Durham Coalfield 1843 (as Hill House), Ordnance Survey first edition 1856, An Eye Plan of the township of Ryhope 1869, Ordnance Survey second edition 1896, third edition 1919, fourth edition 1938. Not shown on the fifth edition of 1960.

A pond is shown on An Eye Plan of the township of Ryhope 1869. It is not shown on any Ordnance Survey maps.

Farm shown on Bell's plan of Durham Coalfield 1843, Ordnance Survey first edition 1856, An Eye Plan of the township of Ryhope 1869, Ordnance Survey second edition 1896, third edition 1919, fourth edition 1938. On the fifth edition of 1960 the farm is much bigger with a training yard to the south.

Aerial photographs show a possible rectilinear enclosure with curvilinear feature inside inside. Evaluation trenching in April 2014 recorded natural clay and sand at a depth of 0.35m below present ground level. Over the subsoil was a grey clay silt topsoil. No archaeological features were identified and no artefacts recovered. The cropmarks are the result of geological variation not prehistoric activity.